Drainage Ditches
Time Limit: 1000MS Memory Limit: 10000KTotal Submissions: 91585 Accepted: 35493Description
Every time it rains on Farmer John's fields, a pond forms over Bessie's favorite clover patch. This means that the clover is covered by water for awhile and takes quite a long time to regrow. Thus, Farmer John has built a set of drainage ditches so that Bessie's clover patch is never covered in water. Instead, the water is drained to a nearby stream. Being an ace engineer, Farmer John has also installed regulators at the beginning of each ditch, so he can control at what rate water flows into that ditch. Farmer John knows not only how many gallons of water each ditch can transport per minute but also the exact layout of the ditches, which feed out of the pond and into each other and stream in a potentially complex network. Given all this information, determine the maximum rate at which water can be transported out of the pond and into the stream. For any given ditch, water flows in only one direction, but there might be a way that water can flow in a circle.
Input
The input includes several cases. For each case, the first line contains two space-separated integers, N (0 <= N <= 200) and M (2 <= M <= 200). N is the number of ditches that Farmer John has dug. M is the number of intersections points for those ditches. Intersection 1 is the pond. Intersection point M is the stream. Each of the following N lines contains three integers, Si, Ei, and Ci. Si and Ei (1 <= Si, Ei <= M) designate the intersections between which this ditch flows. Water will flow through this ditch from Si to Ei. Ci (0 <= Ci <= 10,000,000) is the maximum rate at which water will flow through the ditch.
Output
For each case, output a single integer, the maximum rate at which water may emptied from the pond.
Sample Input
5 4 1 2 40 1 4 20 2 4 20 2 3 30 3 4 10Sample Output
50Source
USACO 93
因为这个题要考虑吧，多次对一条边增加流量，所以要用邻接矩阵来处理。这里给出两个代码，当前弧优化，和非当前弧优化版。
#include <iostream> #include <cstdio> #include <math.h> #include <cstring> #include <queue> #define INF 0x3f3f3f3f using namespace std; int tab[250][250];//邻接矩阵 int dis[250];//距源点距离,分层图 int cur[280]; //当前弧优化 int N,M;//N:点数;M,边数 queue<int> Q; int BFS() { memset(dis,0xff,sizeof(dis));//以-1填充 dis[1]=0; Q.push(1); while (Q.size()) { int head=Q.front(); Q.pop(); for (int i=1; i<=N; i++) if (dis[i]<0 && tab[head][i]>0) { dis[i]=dis[head]+1; Q.push(i); } } if (dis[N]>0) return 1; else return 0;//汇点的DIS小于零,表明BFS不到汇点 } //dfs代表一次增广,函数返回本次增广的流量,返回0表示无法增广 int dfs(int x,int low)//Low是源点到现在最窄的(剩余流量最小)的边的剩余流量 { int a=0; if (x==N) return low;//是汇点 for (int &i=cur[x]; i<=N; i++) if (tab[x][i] >0 //联通 && dis[i]==dis[x]+1 //是分层图的下一层 &&(a=dfs(i,min(low,tab[x][i]))))//能到汇点(a != 0) { tab[x][i]-=a; tab[i][x]+=a; return a; } return 0; } int dinic() { int ans=0,tans; while (BFS())//要不停地建立分层图,如果BFS不到汇点才结束 { for(int i=1;i<=N;i++) cur[i]=1; while(tans=dfs(1,0x7fffffff))ans+=tans;//一次BFS要不停地找增广路,直到找不到为止 } return ans; } int main() { int i,j,f,t,flow,tans; while (scanf("%d%d",&M,&N)!=EOF) { memset(tab,0,sizeof(tab)); for (i=1; i<=M; i++) { scanf("%d%d%d",&f,&t,&flow); tab[f][t]+=flow; } printf("%d\n",dinic()); } } #include <iostream> #include <cstdio> #include <math.h> #include <cstring> #include <queue> #define INF 0x3f3f3f3f using namespace std; int tab[250][250];//邻接矩阵 int dis[250];//距源点距离,分层图 int N,M;//N:点数;M,边数 queue<int> Q; int BFS() { memset(dis,0xff,sizeof(dis));//以-1填充 dis[1]=0; Q.push(1); while (Q.size()) { int head=Q.front(); Q.pop(); for (int i=1; i<=N; i++) if (dis[i]<0 && tab[head][i]>0) { dis[i]=dis[head]+1; Q.push(i); } } if (dis[N]>0) return 1; else return 0;//汇点的DIS小于零,表明BFS不到汇点 } //dfs代表一次增广,函数返回本次增广的流量,返回0表示无法增广 int dfs(int x,int low)//Low是源点到现在最窄的(剩余流量最小)的边的剩余流量 { int a=0; if (x==N) return low;//是汇点 for (int i=1; i<=N; i++) if (tab[x][i] >0 //联通 && dis[i]==dis[x]+1 //是分层图的下一层 &&(a=dfs(i,min(low,tab[x][i]))))//能到汇点(a != 0) { tab[x][i]-=a; tab[i][x]+=a; return a; } return 0; } int dinic() { int ans=0,tans; while (BFS())//要不停地建立分层图,如果BFS不到汇点才结束 { while(tans=dfs(1,0x7fffffff))ans+=tans;//一次BFS要不停地找增广路,直到找不到为止 } return ans; } int main() { int i,j,f,t,flow,tans; while (scanf("%d%d",&M,&N)!=EOF) { memset(tab,0,sizeof(tab)); for (i=1; i<=M; i++) { scanf("%d%d%d",&f,&t,&flow); tab[f][t]+=flow; } printf("%d\n",dinic()); } }风骨散人Chiam 认证博客专家 拖更专业户???? 大学僧，考研狗，没上岸，ACM退役选手。名字的含义：希望可以通过努力，能力让家人拥有富足的生活而不是为了生计而到处奔波。“世人慌慌张张，不过是图碎银几两。偏偏这碎银几两，能解世间惆怅，可让父母安康，可护幼子成长 …”Chiam是 -am爱 China中国文章主要内容：Python,C++,C语言,JAVA,C#等语言的教程，ACM题解、模板、算法等，主要是数据结构，数学和图论设计模式，数据库，计算机网络，操作系统，计算机组成原理，Python爬虫、深度学习、机器学学习，计算机系408考研的所有专业课内容。目前还在更新中，博客园，微信公众号同名“风骨散人”，关注公众号可获软件大礼包
